Overview The MWS6-DD microwave presence detector provides automatic control of lighting loads with optional manual control. The MWS6-DD detects mo
10 Parameter Name Default Value Range / Options Description UHS5 UNLCDHS Channel 1 –Switching Channel Detection Mode Presence Presence or
11 This page intentionally left blank
12 Due to our policy of continual product improvement CP Electronics reserves the right to alter the specification of this product without prior not
2 Detection diagram Area of lower sensitivity Area of high sensitivity Note. If the range is compromised by the ceiling construction / material. Add
3 Choosing a Suitable Location The detector should be sited so that the occupants of the room fall inside the detection pattern shown opposite).
4 Installation The MWS6-DD is designed to be mounted using either: Flush fixing, or Surface fixing, using the optional Surface Mounting Box (p
5 Single channel dimming Channel 1 (switched output) of the MWS6-DD can either be used to switch a separate channel of standard, non-dimming luminai
6 L/OUTLNEBDSPIR-DD SENSORSW1/UPSW2DOWNPLEASE NOTE THAT THEDIMMING SIGNAL IS USED TOSWITCH THE DIMMINGLUMINAIRE ON/OFF ANDTHEREFORE THE 240V FEEDTO
7 When power is applied to the unit, the load will turn on immediately. Set the timeout to 10 seconds, vacate the room or remain very still and wait
8 Basic programming Parameter Name Default Value 0 1 2 3 UHS5 Handset Graphics Description Button Activation On / Raise On Raise
9 Advanced programming Parameter Name Default Value Range / Options Description UHS5 UNLCDHS Detector Parameters Walk Test LED Off On or O
Comments to this Manuals